Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
| *1 | NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE | *2 | SYMBOL EMBLEM |
| ● | Non-reusable part | - | - |
SYMBOL EMBLEM
| *a | Location Pin |
NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
| *a | Reference Values | *b | Edge of Back Door Panel |
| *c | 178.4 mm (7.024 in.) | *d | 95 mm (3.740 in.) |
| *e | 33.3 mm (1.311 in.) | *f | 42.7 mm (1.681 in.) |