Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM
NM19S0E _58 Vehicle Interior _051430 DOOR LOCK _0247900 WIRELESS DOOR LOCK CONTROL SYSTEM UN GENERAL/CONTROL/DETAILS F

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


FUNCTION OF MAIN COMPONENTS


a.

The main components in the wireless door lock control system have the following functions:

Component Function
Door Lock with Motor Assembly Door Lock Motor Drives the motor in response to signals from the main body ECU (multiplex network body ECU) and locks or unlocks the doors.
Door Lock Position Switch Detects whether the doors are locked or unlocked and sends this information to the main body ECU (multiplex network body ECU).
Back Door Lock Assembly Door Lock Motor Drives the motor in response to signals from the main body ECU (multiplex network body ECU) and releases the back door latch.
Back Door Courtesy Light Switch Detects whether the back door is open or closed and sends this information to the main body ECU (multiplex network body ECU).
Door Courtesy Light Switch Assembly Detects whether the doors are open or closed and sends this information to the main body ECU (multiplex network body ECU).
Door Control Receiver Receives a lock or unlock signal from the transmitter and sends this information to the main body ECU (multiplex network body ECU).
Main Body ECU (Multiplex Network Body ECU) Drives all door lock motors in response to signals.
Combination Meter Assembly Receiving the main body ECU (multiplex network body ECU) signals causes to blink the hazard light as an answer back.
Door Control Transmitter Sends the ID code and function code to the door control receiver.



FUNCTION


a.

The wireless door lock control system has the following functions:

Function Outline Customized*
All Doors Lock Pressing the "lock" button of the door control transmitter locks all doors and back door. Not Available
All Doors Unlock Pressing the "unlock" button of the door control transmitter unlocks all doors and back door. Not Available
Automatic Lock If none of the doors are opened for 30 seconds after being unlocked by the wireless door lock control, all the doors are locked again automatically. Available
Answer Back The hazard light blinks once when locking, and blinks twice when unlocking, to inform that the operation has been completed. Available

HINT:

*: Customizable parameters can be configured by means of the customized body electronics system. For details, refer to the Repair Manual.




DIAGNOSIS


a.

If there is a malfunction in the system, the main body ECU (multiplex network body ECU) stores the Diagnostic Trouble Codes (DTCs) in its memory. For details, refer to the Repair Manual.