Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM › from 2016.09
NM19S0E _51 Engine / Hybrid System _051398 1NZ-FE EMISSION CONTROL _0247863 EMISSION CONTROL SYSTEM UN GENERAL/CONTROL/DETAILS F

1NZ-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

2 Three-Way Catalytic converters (TWCs) are used in the front exhaust pipe assembly.


b.

The ECM performs the air fuel ratio feedback control based on signals from the air fuel ratio sensor and the oxygen sensor, and controls the fuel injection amount so that the air fuel ratio comes close to the stoichiometric air fuel ratio at which the highest purifying efficiency of CO, HC and NOx is obtained.


c.

A blowby gas ventilation system, which efficiently ventilates blowby gas containing HC from the crankcase, is used.


d.

An evaporative emission control, which regulates the purge flow of evaporative emission (HC) into the canister in accordance with the engine conditions, is used.


e.

An air fuel ratio sensor and an oxygen sensor heater control, which maintain the temperature of the respective sensors at an appropriate level, are used to improve the detection accuracy of oxygen concentration in exhaust gas.