Home › Engine / Hybrid System › 2NZ-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM › from 2016.09
NM19S0E _51 Engine / Hybrid System _051397 2NZ-FE EMISSION CONTROL _0247862 EMISSION CONTROL SYSTEM UN GENERAL/CONTROL/DETAILS F

2NZ-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the 2NZ-FE emission control system are as follows.

Component Function
TWC The TWCs reduce emissions by oxidation of CO and HC in exhaust gas and reduction of NOx.
Oxygen Sensor This sensor detects the oxygen concentration in the exhaust emission by measuring the electromotive force which is generated in the sensor itself.
Air Fuel Ratio Sensor Is used to determine the concentration of oxygen remaining in the exhaust gas, and has a characteristic where its output is proportional to the air fuel ratio.
Ventilation Valve Sub-assembly Opens and closes the valve using vacuum generated in the intake manifold and controls the flow rate of the blowby gas.
Purge VSV (No. 1 Vacuum Switching Valve Assembly) Open and closes the valve based on signals from the ECM and controls the flow rate of the evaporative emission.
ECM Optimizes the air-fuel ratio according to signals from the oxygen sensor.



SYSTEM CONTROL


a.

Blowby Gas Ventilation System

i.

By introducing blowby gas that has a large amount of HC into the air intake side and burning it again, the system attempts to enhance the emission performance. Returning blowby gas volume is regulated to the appropriate amount corresponding to the engine operating conditions, reducing the engine oil quantity taken away and engine idling speeds.


ii.

The ventilation valve sub-assembly passage returns the blowby gas into the area after the throttle valve in accordance with the intake manifold vacuum.


iii.

When load is low, the passage from the cylinder head cover sub-assembly to the area before the throttle valve increases the air purification performance inside the crankcase by introducing fresh air, and when load is high, the passage circulates the blowby gas together with the ventilation valve sub-assembly side passage due to the intake manifold vacuum.

W105000C06
1.938,1.177 1.698,0.594 1.698,0.594 1.583,0.594 true 1.365,0.521 1.615,0.729 0.25,0.208 10 false *1 2.25,0.563 2.5,0.771 0.25,0.208 10 false *a 4.802,0.542 5.052,0.75 0.25,0.208 10 false *b
*1 Ventilation Valve Sub-assembly - -
*a When load is low *b When load is high
V100135

Blowby Gas
V100136

Fresh Air





CONSTRUCTION


a.

Three-Way Catalytic converter (TWC)

i.

TWCs are provided in the front exhaust pipe assembly.


ii.

This TWC enables improved exhaust emissions.

W105055C03
2.021,2.125 1.604,1.125 1.604,1.125 0.646,1.125 true 0.823,1.125 1.146,2.01 true 0.448,1.031 0.677,1.24 0.229,0.208 10 false *1
*1 TWC - -