Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › from 2017.01
NM19S0E _58 Vehicle Interior _051436 HEATING / AIR CONDITIONING _0247906 AIR CONDITIONING SYSTEM UN GENERAL/CONTROL/DETAILS F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

A Manual air conditioning system or automatic air conditioning system is used.



SPECIFICATION


a.

Performance

Air Conditioning Type Manual Automatic
Heater Heater Output W 4600 ←
Air Flow Volume m3/h 280 ←
Power Consumption W 170 ←
Cooler Cooling Capacity W 4430 ←
Air Flow Volume m3/h 420 ←
Power Consumption W 210 ←


b.

Ventilation and Heater Radiator Unit Sub-assembly

Heater Radiator Unit Sub-assembly Type Straight Flow Aluminum (SFA)-II
Size: W x H x L mm (in.) 201.5 x 140 x 27 (7.9 x 5.5 x 1.1)
Fin Pitch mm (in.) 1.8 (0.07)
Blower with Fan Motor Sub-assembly Motor Type K62-12.5T
Fan Type Semi Sirocco
Fan Size: Dia. x H mm (in.) 145 x 65 (5.7 x 2.6)


c.

Air Conditioning

Cooler Condenser Assembly Type Global Inner-fin Condenser (GIC)
Size: W x H x L mm (in.) 520 x 325 x 11.5 (20.5 x 12.8 x 0.45)
Fin Pitch mm (in.) 2.5 (0.098)
No. 1 Cooler Evaporator Sub-assembly Type Revolutionary super-Slim structure (RS)
Size: W x H x L mm (in.) 199.3 x 231 x 38 (7.8 x 9.1 x 1.5)
Fin Pitch mm (in.) 2.6 (0.1)
Compressor with Pulley Assembly Type 5TSE10C
Pulley Damper Limiter (DL)
Refrigerant Type HFC134a
Charge Volume g 370 +/- 30
Clean Air Filter High Efficiency Type



MAIN FEATURES


a.

The air conditioning system has the following features:

Item Outline
High Performance
·

Neural network control is used so passengers can control the air conditioning accurately for maximum comfort.*

·

A high efficiency type clean air filter is used as the clean air filter.

·

The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control.*


Lightweight A bus connector (air conditioning harness assembly) with a built-in IC is used in a lightweight wire harness design with a reduced number of wires. The use of this connector means that pulse pattern type servo motors are used.*
Compact
·

A semi-center location air conditioning unit in which the No. 1 cooler evaporator sub-assembly and heater radiator unit sub-assembly are placed in the vehicle's longitudinal direction is used.

·

A blower motor with a built-in blower motor controller is used in a compact construction.*


Others

The following parts are used to ensure high cooling or heating performance while realizing a compact and lightweight construction.

-

Revolutionary super-Slim structure (RS) type No. 1 cooler evaporator sub-assembly

-

Straight Flow Aluminum (SFA)-II type heater radiator unit sub-assembly

-

Global Inner-fin Condenser (GIC) Sub-cool Condenser

-

Continuously variable capacity type compressor with pulley assembly (5TSE10C type)




*: Models with Automatic Air Conditioning System