Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2017.01
NM19S0E _57 Power Source / Network _051429 NETWORKING _0247898 CAN COMMUNICATION SYSTEM UN GENERAL/CONTROL/DETAILS F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

The Controller Area Network (CAN) is a serial data communication network for real time application. It is a multiplex communication network to be equipped in a vehicle, and has communication speeds of 500 kbps (HS-CAN), and the ability to detect malfunctions.


b.

The HS-CAN consists of the V bus, bus 2*1, and bus 3*1.


c.

The CAN has 2 terminating resistors which are necessary for accurate judgment of communication on the main bus.


d.

The terminating resistors for each bus are located as shown in the following table.

Bus Terminating Resistor Location

*1: Models with Toyota safety sense

*2: Models without Toyota safety sense

V Bus*1 Central Gateway ECU (Network Gateway ECU)
V Bus*2
·

ECM

·

Combination Meter Assembly


Bus 2*1
Bus 3*1 Central Gateway ECU (Network Gateway ECU)