Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2017.01
NM19S0E _57 Power Source / Network _051429 NETWORKING _0247898 CAN COMMUNICATION SYSTEM UN GENERAL/CONTROL/DETAILS F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL/CONTROL/DETAILS  DETAILS  


DIAGNOSIS


a.

If a malfunction occurs on the CAN communication bus, ECUs that are connected to the CAN communication bus store the Diagnostic Trouble Code (DTC) in memory.


b.

The 5-digit DTCs can be read by connecting the Global TechStream (GTS) to DLC3.


c.

DLC3 is equipped with a CAN-H and a CAN-L terminal on the bus to allow CAN diagnosis. It is possible to determine if there is an open or short in the wires of the bus by measuring the resistance value between these terminals.


d.

For details, refer to the Repair Manual.