CONSTRUCTION
Front Suspension Support Sub-Assembly and Front Coil Spring
The front suspension support sub-assembly has been adopted the construction that the support is connected in one point. As a result, a compact and lightweight construction is offered.
A pigtail type of front coil spring is used where the top and bottom diameters are different, creating a compact and lightweight construction. Lateral force reduction springs are used to control the reaction force line of the front coil spring, and reduce the bending force applied to the front shock absorber assembly. This reduces suspension friction, delivering a very comfortable ride.
A semi-airtight shock absorber dust cover which is attached to the absorber cap and moves with the shock absorber has been adopted. This reduces the gap between the shock absorber dust cover and shock absorber assembly, enhancing its ability to resist the intrusion of foreign matter.
| *1 | Front Suspension Support Sub-assembly | *2 | Dust Cover |
| *3 | Front Coil Spring | *4 | Strut Mounting Bearing |
| *5 | Front Spring Bumper | *6 | Absorber Cap |
| *7 | Front Shock Absorber Assembly | - | - |
| *a | The illustrations shown are examples only. | - | - |
Front Shock Absorber Assembly
A low-pressure (N2) gas sealed front shock absorber with high response type piston valve is used to achieve a high level of controllability, driving stability and ride comfort.
A low friction piston band has been adopted. Low friction ensures responsiveness and both ends of the piston band are closed to stabilize the damping force when switching between compression and expansion. This ensures excellent ride comfort.
A high response type piston valve provides damping force at very low shock absorber speeds, while also ensuring sufficient flow channel at medium and high speeds. This enhances steering response and suppresses high-frequency oscillations resulting in enhanced ride comfort.
| *1 | Oil Seal | *2 | Rebound Stopper |
| *3 | High Response Type Piston Valve | *4 | Base Valve |
| *5 | Low-pressure (N2) Gas | *6 | Oil |
| *7 | Piston Band | - | - |
| *a | When shock absorber speed is low. | *b | When shock absorber speed is medium or high. |
| *c | Extension Passage | *d | Compression Passage |
| *e | The illustrations shown are examples only. | - | - |
To prevent hazardous conditions, make sure to empty the gas from the shock absorber before discarding an N2 gas sealed shock absorber. For details, refer to the Repair Manual.
Front Lower No. 1 Suspension Arm Sub-assembly
L-shaped front lower suspension arm is constructed from pressed high-tensile steel to ensure strength, rigidity and lightweight.
| *1 | Front Lower No. 1 Suspension Arm Sub-assembly | *2 | No. 1 Bush |
| *3 | No. 2 Bush | *4 | Front Lower Ball Joint |
| *a | No. 1 Bush Cross Section | *b | No. 2 Bush Cross Section |
| *c | No. 2 Bush View from Top Side | - | - |