Home › General › SPECIFICATIONS › 1NZ-FE INTAKE / EXHAUST
RM19S0E _V1 General _051446 SPECIFICATIONS _0247980 1NZ-FE INTAKE / EXHAUST F

SPECIFICATIONS  1NZ-FE INTAKE / EXHAUST  TORQUE SPECIFICATIONS  


Part Tightened N*m kgf*cm ft.*lbf
Intake manifold x Cylinder head sub-assembly 30 306 22
Wire harness bracket x Intake manifold 11 112 8
Stud bolt x Intake manifold 4.0 41 35 in.*lbf
Front floor center brace x Body 30 307 22
No. 1 exhaust manifold heat insulator x Exhaust manifold 8.0 82 71 in.*lbf
Exhaust manifold x Cylinder head sub-assembly 27 275 20
Manifold support bracket x Exhaust manifold x Cylinder head sub-assembly 44 449 33
Heated oxygen sensor x Exhaust manifold without SST 44 449 33
with SST 40 408 30
Tail exhaust pipe assembly x Front exhaust pipe assembly 43 438 32
Front exhaust pipe assembly x Exhaust manifold 43 438 32
Exhaust tail pipe assembly x Front exhaust pipe assembly 43 438 32