Home › General › SPECIFICATIONS › CLUTCH
RM19S0E _V1 General _051446 SPECIFICATIONS _0248002 CLUTCH F

SPECIFICATIONS  CLUTCH  SERVICE DATA  


Clutch Pedal
Pedal height from floor (for LHD) for 1NZ-FE 132.1 to 142.1 mm (5.201 to 5.594 in.)
for 2NZ-FE 117.2 to 127.2 mm (4.614 to 5.008 in.)
Pedal height from floor (for RHD) for 1NZ-FE 159.3 to 169.3 mm (6.272 to 6.665 in.)
for 2NZ-FE 144.4 to 154.4 mm (5.685 to 6.079 in.)
Pedal free play - 5.0 to 15.0 mm (0.197 to 0.591 in.)
Push rod play at pedal top - 1.0 to 5.0 mm (0.039 to 0.197 in.)
Clutch release point from pedal full stroke end position - 25 mm (0.984 in.) or more
Pedal stroke (for LHD)
(Reference)
for 1NZ-FE 137 to 147 mm (5.394 to 5.787 in.)
for 2NZ-FE 120 to 130 mm (4.724 to 5.118 in.)
Pedal stroke (for RHD)
(Reference)
for 1NZ-FE 137 to 147 mm (5.394 to 5.787 in.)
for 2NZ-FE 120 to 130 mm (4.724 to 5.118 in.)
Clutch start switch clearance for LHD 1NZ-FE 2.1 to 5.1 mm (0.083 to 0.201 in.)
for LHD 2NZ-FE 2.0 to 5.0 mm (0.079 to 0.197 in.)
for RHD 2.5 to 5.5 mm (0.098 to 0.217 in.)
No. 2 clutch start switch clearance for 1NZ-FE 0.5 to 3.5 mm (0.020 to 0.138 in.)
for 2NZ-FE 2.5 to 5.5 mm (0.098 to 0.217 in.)

Clutch Unit
Clutch disc rivet depth Minimum 0.3 mm (0.0118 in.)
Clutch disc runout Maximum 0.8 mm (0.0315 in.)
Clutch cover diaphragm spring wear Maximum depth 0.5 mm (0.0197 in.)
Maximum width 6.0 mm (0.236 in.)
Flywheel runout Maximum 0.1 mm (0.00394 in.)
Clutch cover diaphragm spring tip non-alignment Maximum 0.5 mm (0.0197 in.)

Clutch Pedal Switch
Clutch start switch assembly
Standard resistance
1 - 2
ON (Pushed in) Below 1 Ω
OFF (Released) 10 kΩ or higher
No. 2 clutch start switch assembly
Standard resistance
1 - 2
ON (Pushed in) Below 1 Ω
OFF (Released) 10 kΩ or higher