RM19S0E
_V1
General
_051446
SPECIFICATIONS
_0248019
1NZ-FE BATTERY / CHARGING
F
SPECIFICATIONS 1NZ-FE BATTERY / CHARGING SERVICE DATA
| Generator brush holder assembly brush exposed length
|
Standard exposed length
|
9.5 to 11.5 mm (0.374 to 0.453 in.)
|
| Minimum exposed length
|
4.5mm (0.177 in.)
|
| Generator rotor assembly resistance
|
Slip ring - Slip ring
|
1.7 to 2.1 Ω at 20°C (68°F)
|
| Slip ring - Rotor
|
10 MΩ or higher
|
| Generator rotor assembly slip ring diameter
|
Standard diameter
|
14.2 to 14.4 mm (0.559 to 0.567 in.)
|
| Minimum diameter
|
14.0 mm (0.551 in.)
|
| Generator drive end frame assembly resistance
|
Coil lead - Coil lead
|
Below 1Ω
|
| Coil lead - Generator drive end frame assembly
|
10 kΩ or higher
|
| Generator holder with rectifier resistance
|
P1, P2, P3 - B
|
Resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.
|
| P1, P2, P3 - E
|
Resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.
|
| Generator regulator assembly resistance
|
Terminals F - Terminals B
|
When the positive and negative poles between terminals F and B are exchanged, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.
|
| Terminals E - Terminals F
|
When the positive and negative poles between terminals E and F are exchanged, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction.
|