Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › SFI SYSTEM › 2011.08–2015.06
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248054 SFI SYSTEM L

2NZ-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).


·

Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See page Drivetrain>U441E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).

·

Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components (See page Engine / Hybrid System>2NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).

·

Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM (See page Engine / Hybrid System>2NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).




USING INTELLIGENT TESTER


CAUTION:
Observe the following items for safety reasons:
·

Read the intelligent tester instruction books before using the tester.

·

Make sure that the tester cable is not caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.

·

When driving the vehicle for testing purposes while using the tester, 2 persons are required. One person drives the vehicle and the other operates the tester.