11101J
1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 6.9 to 7.9 Ω |
| *a | Component without harness connected
(Camshaft Timing Oil Control Valve Assembly) |
If the result is not as specified, replace the oil control valve assembly.
Check the operation
Connect the positive (+) lead from a battery to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.
Confirm that the valve moves freely and does not stick in any position.
If necessary, replace the camshaft timing oil control valve assembly.
Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.
| *a | Component without harness connected
(Camshaft Timing Oil Control Valve Assembly) |
| *b | When applied |
| *c | When cut off |