Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248059 ACCELERATOR PEDAL A

2NZ-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)

a.

Install the accelerator pedal sensor assembly with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Do not disassemble the accelerator or subjected to a strong impact, replace it.

·

If a component has been dropped or subjected to a strong impact, replace it.




b.

Connect the connector of the accelerator pedal sensor assembly.


Hide 78110K 2.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)

a.

Install the accelerator pedal sensor assembly with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Do not disassemble the accelerator or subjected to a strong impact, replace it.

·

If a component has been dropped or subjected to a strong impact, replace it.




b.

Connect the connector of the accelerator pedal sensor assembly.