Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248059 ACCELERATOR PEDAL G

2NZ-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No.1 and Accel Sensor Out No.2.


e.

Read the values displayed on the intelligent tester.

Standard Voltage:
Tester Display Condition Specified Condition
Accel Sensor Out No.1 Accelerator pedal is released 0.5 to 1.1 V
Accelerator pedal is fully depressed 2.6 to 4.5 V
Accel Sensor Out No.2 Accelerator pedal is released 1.2 to 2.0 V
Accelerator pedal is fully depressed 3.4 to 4.7 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.