Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › MASS AIR FLOW METER
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248060 MASS AIR FLOW METER G

2NZ-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.
A244961E04
0.719,2.479 0.927,2.865 0.927,2.865 0.74,2.344 false 0.938,2.865 1.177,3.052 0.24,0.188 10 false *1

Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

Text in Illustration
*1 Platinum Hot Wire (Heater)

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter.


b.
A250616E01
0.07,0.058 0.240,0.219 0.170,0.161 10 *a 2.461,0.844 2.661,0.995 0.200,0.151 10 E2 3.036,0.844 3.340,0.995 0.304,0.151 10 THA 2.998,0.929 2.924,1.393 false 2.717,0.929 2.792,1.393 false

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Mass Air Flow Meter)

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
1 (THA) - 2 (E2) 20°C (68°F) 2.21 to 2.69 kΩ
1 (THA) - 2 (E2) 60°C (140°F) 0.49 to 0.67 kΩ


If the resistance is not as specified, replace the mass air flow meter.