Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248061 CAMSHAFT POSITION SENSOR A

2NZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 17705 2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

Hide 28800 3.REMOVE BATTERY

A248909

a.

Disconnect the battery terminal.


b.

Remove the 2 nuts and the battery clamp.


c.

Remove the battery.


Hide 11101E 4.REMOVE CAMSHAFT POSITION SENSOR

a.
A183419

Disconnect the camshaft position sensor connector.


b.
A183420

Remove the bolt and camshaft position sensor.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.