Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248062 CRANKSHAFT POSITION SENSOR A

2NZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 15100Q 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



b.

Install the crankshaft position sensor with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

Do not twist the O-ring.

·

If a component has been dropped or subjected to a strong impact, replace it.




c.

Connect the crankshaft position sensor connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK

Hide 51441C 3.INSTALL ENGINE UNDER COVER RH (for Plastic Type)

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

Hide 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)