Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248062 CRANKSHAFT POSITION SENSOR A

2NZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51441C 1.REMOVE ENGINE UNDER COVER RH (for Plastic Type)

Hide 51405A 2.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Hide 15100Q 3.REMOVE CRANKSHAFT POSITION SENSOR

a.
A182411

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.