Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR(for Sensor 2) › 2011.08–2016.09
RM19S0E _51 Engine / Hybrid System _051449 2NZ-FE ENGINE CONTROL _0248067 HEATED OXYGEN SENSOR(for Sensor 2) A

2NZ-FE ENGINE CONTROL  HEATED OXYGEN SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89465A 1.INSTALL HEATED OXYGEN SENSOR (for Sensor 2)

a.
A251202E03
1.885,0.646 2,0.271 2,0.271 2.104,0.271 false 2.156,0.177 2.542,0.427 0.385,0.25 10 false SST 0.427,0.917 0.667,1.104 0.24,0.188 10 true *a 0.844,0.271 1.063,0.458 0.219,0.188 10 true *b

Using SST, install the heated oxygen sensor.

Text in Illustration
*a Fulcrum Length 300 mm
*b Fulcrum Length 30 mm

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

This torque value is effective when SST is parallel to the torque wrench.




b.

Pass the connector through the hole into the inside of the vehicle and install the oxygen sensor wire grommet.


c.

Connect the heated oxygen sensor connector.


d.

Install the wire harness to the wire harness bracket.


Hide 2.INSPECT FOR EXHAUST GAS LEAK

Hide 58910C 3.INSTALL REAR CONSOLE BOX ASSEMBLY