11117A
1.REMOVE NO. 1 WITH HEAD TAPER SCREW PLUG
Using a 10 mm socket hexagon wrench, remove the No. 1 with head taper screw plug and the gasket.
13751
2.REMOVE VALVE LIFTER
Remove the 16 valve lifters from the cylinder head.
Keep the valve lifters in the correct order so that they can be returned to their original locations when reassembled.
11117B
3.REMOVE NO. 2 WITH HEAD TAPER SCREW PLUG
Using an 8 mm socket hexagon wrench, remove the No. 2 with head taper screw plug and the gasket.
15678A
4.REMOVE OIL CONTROL VALVE FILTER
13711
5.REMOVE INTAKE VALVE
Using SST, compress and remove the valve retainer locks.
Arrange the removed parts in the correct order.
Remove the retainer, valve spring and valve.
Arrange the removed parts in the correct order.
13715
6.REMOVE EXHAUST VALVE
Using SST, compress and remove the valve retainer locks.
Arrange the removed parts in the correct order.
Remove the retainer, valve spring and valve.
Arrange the removed parts in the correct order.
13711A
7.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the oil seal.
13734
8.REMOVE VALVE SPRING SEAT
Using compressed air and Magnet Hand, remove the valve spring seats by blowing air onto them.
15104E
9.REMOVE STUD BOLT
11151A
10.REMOVE CAMSHAFT BEARING CAP SETTING RING PIN