13711
1.REPAIR INTAKE VALVE
Repair the intake valve seat.
Releasing the seat-cutter pressure gradually helps to the make valve seat face smoother.
If the seating is too high on the valve face, use 20° and 45° cutters to correct it.
If the seating is too low on the valve face, use 75° and 45° cutters to correct it.
Hand-lap the valve and valve seat with an abrasive compound.
Recheck the valve seating position.
13715
2.REPAIR EXHAUST VALVE
Releasing the seat-cutter pressure gradually helps to make the valve seat face smoother.
If the seating is too high on the valve face, use 20° and 45° cutters to correct it.
If the seating is too low on the valve face, use 75° and 45° cutters to correct it.
Hand-lap the valve and valve seat with an abrasive compound.
Recheck the valve seating position.