Home › Engine / Hybrid System › 2NZ-FE ENGINE MECHANICAL › CYLINDER HEAD
RM19S0E _51 Engine / Hybrid System _051451 2NZ-FE ENGINE MECHANICAL _0248081 CYLINDER HEAD A

2NZ-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 13711 1.REPAIR INTAKE VALVE

A370169E02
1.135,1.667 2.208,2.063 1.073,0.396 10 false 1.0 to 1.4 mm (0.04 to 0.06 in.) 2.75,0.354 3.063,0.573 0.313,0.219 10 false 45° 2.927,0.635 3.24,0.854 0.313,0.219 10 false 20°

a.

Repair the intake valve seat.

NOTICE:

Releasing the seat-cutter pressure gradually helps to the make valve seat face smoother.



b.

If the seating is too high on the valve face, use 20° and 45° cutters to correct it.


c.
A370170E02
1.25,1.542 2.302,1.958 1.052,0.417 10 false 1.0 to 1.4 mm (0.04 to 0.06 in.) 2.625,0.344 3,0.563 0.375,0.219 10 false 75° 3.01,0.823 3.302,1.063 0.292,0.24 10 false 45°

If the seating is too low on the valve face, use 75° and 45° cutters to correct it.


d.

Hand-lap the valve and valve seat with an abrasive compound.


e.

Recheck the valve seating position.


Hide 13715 2.REPAIR EXHAUST VALVE

NOTICE:

Releasing the seat-cutter pressure gradually helps to make the valve seat face smoother.


a.

If the seating is too high on the valve face, use 20° and 45° cutters to correct it.


b.

If the seating is too low on the valve face, use 75° and 45° cutters to correct it.


c.

Hand-lap the valve and valve seat with an abrasive compound.


d.

Recheck the valve seating position.