Home › Engine / Hybrid System › 2NZ-FE ENGINE MECHANICAL › DRIVE BELT
RM19S0E _51 Engine / Hybrid System _051451 2NZ-FE ENGINE MECHANICAL _0248084 DRIVE BELT G

2NZ-FE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT FOR FAN AND GENERATOR V BELT

A219362

a.

Check the fan and generator V belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The fan and generator V belt is cracked.

·

The fan and generator V belt is worn out to the extent that the cords are exposed.

·

The fan and generator V belt has chunks missing from the ribs.



b.
A219361E03
2.466,1.497 2.654,1.688 0.188,0.191 10 *b 0.592,1.497 0.780,1.688 0.188,0.191 10 *a

Check that the fan and generator V belt fits properly in the ribbed grooves.

Text in Illustration
*a Correct
*b Incorrect

HINT:

Check with your hand to confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



c.
A116200E05
0.096,0.077 0.317,0.259 0.220,0.181 10 *A 0.096,2.235 0.300,2.417 0.204,0.181 10 *B

Inspect the V belt deflection and tension.

Text in Illustration
*A w/o Air Conditioner
*B w/ Air Conditioner

Deflection:
Item Specified Condition
New belt 8.0 to 9.0 mm (0.31 to 0.35 in)
Used belt 12.5 to 13.5 mm (0.49 to 0.53 in)


Tension:
Item Specified Condition
New belt 700 to 800 N (71 to 82 kg, 157 to 180 lb)
Used belt 300 to 400 N (31 to 41 kg, 67 to 90 lb)


If the V belt deflection is not as specified, adjust it.

HINT:
·

When inspecting the V belt deflection, apply 98 N (10 kgf) tensile force to it.

·

Perform the V belt inspection and adjustment while the engine is cold.

·

V-ribbed belt tension and deflection should be checked immediately after installation of a new belt, and after cranking the engine when inspecting a used belt.

·

Check the V belt deflection at the point between the specified pulleys where the deflection is greatest.

·

When installing a new belt, set its tension to the intermediate value of the specification.

·

When inspecting a belt which has been used for over 5 minutes, apply the Used Belt specifications.

·

When reinstalling a belt which has been used for over 5 minutes, adjust its deflection and tension to the intermediate values of each Used Belt specification.

·

V-ribbed belt tension and deflection should be checked after 2 revolutions of engine cranking.

·

When using a belt tension gauge, confirm its accuracy by using a master gauge first.