23250
1.INSPECT FUEL INJECTOR ASSEMBLY
Check the resistance.
| *1 | Ohmmeter |
| *a | Component without harness connected
(Fuel Injector Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 11.6 to 12.4 Ω |
If the result is not as specified, replace the injector assembly.
Check the operation.
Perform the inspection in a well-ventilated area.
Do not perform the inspection near any open flames.
Connect SST (fuel tube connector) to SST (hose), and then connect them to the fuel pipe (vehicle side).
| *1 | Fuel Pipe |
| *2 | SST (Clip) |
| *3 | SST (Fuel Tube Connector) |
| *4 | SST (Hose) |
Install the new O-ring onto the fuel injector.
| *1 | SST (Clip) |
| *2 | SST (Adapter) |
| *3 | SST (Hose) |
| *4 | O-Ring |
| *5 | SST (Clamp) |
| *6 | Vinyl Tube |
Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).
Put the injector into a graduated cylinder.
Install a suitable vinyl tube onto the injector assembly to prevent gasoline splashes.
Operate the fuel pump (See page Engine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM>DATA LIST / ACTIVE TEST).
Connect SST (wire) to the injector assembly and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Positive terminal - Ground terminal | Per 15 seconds | 47 to 58 cm3 (2.9 to 3.5 cu in.) |
| *1 | SST (Wire) |
|
Connect |
11 cm3 (0.7 cu in.) or less
Always do the switching at the battery side.
If the injection volume is not as specified, replace the injector assembly.
Check for leaks.
In the condition above, disconnect the test probes of SST (wire) from the battery and check if the fuel leaks from the injector.
1 drop or less every 12 minutes