Home › Engine / Hybrid System › 2NZ-FE FUEL › FUEL PUMP
RM19S0E _51 Engine / Hybrid System _051452 2NZ-FE FUEL _0248093 FUEL PUMP A

2NZ-FE FUEL  FUEL PUMP  DISASSEMBLY  


PROCEDURE

Hide 77785 2.REMOVE FUEL PUMP HARNESS

a.
A247519

Disconnect the 2 connectors and remove the fuel pump harness.


Hide 23217D 3.REMOVE FUEL PUMP FILTER

a.
A247520

Disengage the 3 claws and remove the fuel pump.

NOTICE:

Do not damage the fuel pump filter.



Hide 23221 4.REMOVE FUEL PUMP

a.
A246971

Holding the fuel pump filter by the plastic resin part, remove the fuel pump.

NOTICE:

Be careful not to let foreign matter enter the fuel pump or the fuel pump filter.



b.
A248126E01
2.244,0.642 2.564,0.51 false 2.23,0.814 2.55,0.923 false 2.592,0.439 2.755,0.596 0.163,0.157 10 *1 2.577,0.849 2.740,1.007 0.163,0.157 10 *2 2.209,1.785 2.372,1.943 0.163,0.157 10 *a 2.25,2.349 2.413,2.507 0.163,0.158 10 *a

Remove the O-ring and fuel pump spacer from the fuel pump.

Text in Illustration
*1 O-ring
*2 Fuel Pump Spacer
*a (5 mm (0.1969 in.)

NOTICE:

Be careful not to damage the sealing surface.


HINT:

If the O-ring still remains in the No. 1 fuel suction support, remove it using a wire tip (φ1 mm (0.0394 in.)) that is formed as shown in the illustration.



Hide 77175 5.REMOVE NO. 2 FUEL SUCTION SUPPORT

a.
A247523

Disengage the 3 claws and the clamp as shown in the illustration, and remove the No. 2 fuel suction support from the No. 1 fuel suction support.

NOTICE:

Be careful not to damage No. 1 fuel support or No. 2 fuel support.



Hide 23280J 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.
A247524

Remove the fuel pressure regulator assembly from the No. 1 fuel suction support.

NOTICE:
·

Be careful not to damage No. 1 fuel suction support.

·

Make sure that foreign material does not enter the fuel passages of the No. 1 fuel suction support.




Hide 77174 7.REMOVE NO. 1 FUEL SUCTION SUPPORT

a.
A247526E01
2.177,2.956 2.411,3.152 0.234,0.196 2.227,3.038 2.377,3.181 0.150,0.142 10 *a 2.019,2.592 2.315,3.051 false

Disengage the 3 claws as shown in the illustration.

Text in Illustration
*a Lock


b.

Release the lock, disengage the 2 claws, then slide the No. 1 fuel suction support and remove it.


c.
A247527

Remove the O-ring from the fuel suction tube assembly.