83320
1.INSPECT FUEL SENDER GAUGE ASSEMBLY
Check the operation.
Check that the float moves smoothly between the F level (upper end) and E level (lower end).
| *A | Triangular float type | *B | Rectangular float type |
| *a | Component without wire harness connected
(Fuel Sender Gauge Assembly) |
- | - |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition (Triangular float type) | Specified Condition (Rectangular float type) |
|---|---|---|---|
| 1 - 2 | F (Upper End) | 12.0 to 18.0 Ω | 13.5 to 16.5 Ω |
| 1 - 2 | Between F (Upper End) - E (Lower End) | 12.0 to 415.0 Ω (Gradually Change) | 13.5 to 414.5 Ω (Gradually Change) |
| 1 - 2 | E (Lower End) | 405.0 to 415.0 Ω | 405.5 to 414.5 Ω |
If the result is not as specified, replace the fuel sender gauge assembly.