Home › Engine / Hybrid System › 1NZ-FE FUEL › FUEL SENDER GAUGE ASSEMBLY
RM19S0E _51 Engine / Hybrid System _051453 1NZ-FE FUEL _0248100 FUEL SENDER GAUGE ASSEMBLY G

1NZ-FE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check the operation.

i.

Check that the float moves smoothly between the F level (upper end) and E level (lower end).

A298122E02
2.896,0 4.302,0.979 1.406,0.979 1.219,1.042 0.802,1.042 false 1.219,2.573 0.802,2.573 false 5.125,1.094 4.708,1.094 false 5.208,2.563 4.719,2.563 false 2.958,0.094 3.323,0.458 0.365,0.365 10 false *a 0.667,0.25 1.031,0.615 0.365,0.365 10 false *A 6.448,0.271 6.813,0.635 0.365,0.365 10 false *B 0.667,0.948 1.229,1.292 0.563,0.344 10 false F 0.667,2.479 1.229,2.719 0.563,0.24 10 false E 4.583,1.01 5.146,1.354 0.563,0.344 10 false F 4.573,2.479 5.135,2.719 0.563,0.24 10 false E

Text in Illustration
*A Triangular float type *B Rectangular float type
*a Component without wire harness connected
(Fuel Sender Gauge Assembly)
- -



b.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition (Triangular float type) Specified Condition (Rectangular float type)
1 - 2 F (Upper End) 12.0 to 18.0 Ω 13.5 to 16.5 Ω
1 - 2 Between F (Upper End) - E (Lower End) 12.0 to 415.0 Ω (Gradually Change) 13.5 to 414.5 Ω (Gradually Change)
1 - 2 E (Lower End) 405.0 to 415.0 Ω 405.5 to 414.5 Ω


If the result is not as specified, replace the fuel sender gauge assembly.