Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › CANISTER
RM19S0E _51 Engine / Hybrid System _051454 1NZ-FE EMISSION CONTROL _0248105 CANISTER G

1NZ-FE EMISSION CONTROL  CANISTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK CHARCOAL CANISTER

a.

Inspect the ventilation of the canister.

i.
A248554E05
0.583,1.104 1.292,0.844 false 1.25,1.906 1.646,1.521 false 0.406,1 0.563,1.146 0.156,0.146 10 false *a 1.104,1.896 1.26,2.042 0.156,0.146 10 false *b 2.365,1.99 2.521,2.135 0.156,0.146 10 true *c

Open the fuel tank cap, apply compressed air into port B and check that the air flows out from port A.

Text in Illustration
*a Port A
*b Port B
*c Air

OK:

The air flows out from the port A.




b.

Inspect the check valve.

i.
A248555E07
1.552,1.906 1.677,1.469 false 1.323,0.708 0.979,0.406 false 0.792,0.281 1.01,0.458 0.219,0.177 10 false *a 1.427,1.906 1.698,2.063 0.271,0.156 10 false *b 2.094,1.885 2.281,2.042 0.188,0.156 10 false *c

Open the fuel tank cap, close the port A, and apply the compressed air from the port B.

Text in Illustration
*a Port A
*b Port B
*c Air

OK:

Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches the specified level.



ii.
A248556E05
0.473,0.22 0.712,0.375 0.239,0.155 10 *a 0.93,1.854 1.214,2.034 0.284,0.180 10 *b 0.654,0.342 0.995,0.647 false 1.056,1.854 1.216,1.403 false

Open the fuel tank cap, close the port A, and apply a vacuum from the port B, using a vacuum pump.

Text in Illustration
*a Port A
*b Port B

OK:

The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches the specified level.