Home › Engine / Hybrid System › 2NZ-FE EMISSION CONTROL › PURGE VALVE › 2011.08–2015.06
RM19S0E _51 Engine / Hybrid System _051455 2NZ-FE EMISSION CONTROL _0248106 PURGE VALVE G

2NZ-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

a.
A173833E01
0.042,0 0.527,0.291 0.486,0.291 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 26 to 30 Ω


Text in Illustration
*a Component without harness connected
(No. 1 Vacuum Switching Valve Assembly)

If the result is not as specified, replace the No. 1 vacuum switching valve assembly.


b.

Check operation of the No. 1 vacuum switching valve assembly.

i.

Check that air does not flow from port E to port F.


ii.

Apply battery voltage across the terminals.


iii.
A179486E01
1.032,0.779 1.032,0.313 false 0.934,0.125 1.138,0.270 0.204,0.145 10 *1 0.713,1.719 0.959,1.977 false 0.976,1.96 1.275,2.127 0.298,0.167 10 *2 0.066,0.016 0.402,0.230 0.336,0.214 10 *a

Check that air flows from port E to port F. If the result is not as specified, replace the No. 1 vacuum switching valve assembly.

Text in Illustration
*1 Port E
*2 Port F
*a Component without harness connected
(No. 1 Vacuum Switching Valve Assembly)