Home › Engine / Hybrid System › 2NZ-FE EMISSION CONTROL › CANISTER
RM19S0E _51 Engine / Hybrid System _051455 2NZ-FE EMISSION CONTROL _0248109 CANISTER G

2NZ-FE EMISSION CONTROL  CANISTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK CHARCOAL CANISTER

a.

Inspect the ventilation of the canister.

i.
A248554E04
1.281,0.865 0.865,0.667 0.865,0.667 0.74,0.667 true 1.698,1.563 1.313,1.948 1.313,1.948 1.24,1.948 true 0.542,0.573 0.781,0.823 0.24,0.25 10 false *a 1.083,1.865 1.271,2.052 0.188,0.188 10 true *b 2,1.906 2.229,2.104 0.229,0.198 10 false *c

Open the fuel tank cap, apply compressed air into port B and check that the air flows out from port A.

Text in Illustration
*a Port A
*b Port B
*c Air

OK:

The air flows out from the port A.




b.

Inspect the check valve.

i.
A248555E05
1.302,0.698 1.042,0.396 1.042,0.396 0.958,0.396 true 1.667,1.479 1.667,1.99 1.667,1.99 1.583,1.99 true 0.792,0.302 1.01,0.479 0.219,0.177 10 false *a 1.396,1.906 1.667,2.063 0.271,0.156 10 false *b 2.094,1.885 2.281,2.042 0.188,0.156 10 false *c

Open the fuel tank cap, close the port A, and apply the compressed air from the port B.

Text in Illustration
*a Port A
*b Port B
*c Air

OK:

Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches the specified level.



ii.
A248556E07
0.99,0.698 0.719,0.396 0.719,0.396 0.635,0.396 true 1.219,1.448 1.219,2 1.219,2 1.135,2 true 0.479,0.292 0.719,0.448 0.24,0.156 10 false *a 0.969,1.896 1.25,2.073 0.281,0.177 10 false *b

Open the fuel tank cap, close the port A, and apply a vacuum from the port B, using a vacuum pump.

Text in Illustration
*a Port A
*b Port B

OK:

The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches the specified level.