Home › Engine / Hybrid System › 1NZ-FE INTAKE / EXHAUST › EXHAUST MANIFOLD › 2011.08–2014.07
RM19S0E _51 Engine / Hybrid System _051456 1NZ-FE INTAKE / EXHAUST _0248113 EXHAUST MANIFOLD A

1NZ-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 89465 1.REMOVE HEATED OXYGEN SENSOR (for Sensor 1)

Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 57533B 3.REMOVE FRONT FLOOR CENTER BRACE (w/ Side Mudguard)

A259843

a.

Remove the 2 bolts and the front floor center brace from the body.


Hide 17410 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A250069

Peel back the floor carpet.


b.
A250070

Disconnect the heated oxygen sensor connector.


c.

Remove the oxygen sensor wire grommet and pass the connector through the hole to the outside of the vehicle.


d.
A247548

Remove the 2 bolts and 2 compression springs from the exhaust manifold.


e.
A247550

Remove the 2 bolts and 2 compression springs from the tail exhaust pipe assembly.


f.

Remove the 3 exhaust pipe supports and the front exhaust pipe assembly.


Hide 17451 5.REMOVE EXHAUST PIPE GASKET

a.

Remove the exhaust pipe gasket from the exhaust manifold.


Hide 17451A 6.REMOVE NO. 2 EXHAUST PIPE GASKET

a.

Remove the No. 2 exhaust pipe gasket from the front exhaust pipe assembly.


Hide 12363A 7.SEPARATE ENGINE MOVING CONTROL ROD

a.
A250094

Remove the bolt and the engine moving control rod.


Hide 17167 8.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A247612

Disengage the 2 wire harness clamps and separate the engine wire harness.


b.

Remove the bolt and the wire harness bracket.


c.
A166743

Remove the 4 bolts and the No. 1 exhaust manifold heat insulator.


Hide 25591 9.REMOVE MANIFOLD SUPPORT BRACKET

a.
A143272

Remove the 3 bolts and the manifold support bracket.


Hide 17141 10.REMOVE EXHAUST MANIFOLD

a.
A254827

Remove the 3 bolts, 2 nuts and the exhaust manifold.


b.

Remove the gasket from the cylinder head assembly.