17111
1.INSTALL INTAKE MANIFOLD
Install the gasket to the intake manifold.
Temporarily install the intake manifold onto the cylinder head sub-assembly with the 3 bolts and 2 nuts.
Tighten the 3 bolts and 2 nuts in the order shown in the illustration.
Install the oil level dipstick.
Engage the wire harness clamp and install the wire harness to the intake manifold.
Install the 2 wire harness brackets with the 2 bolts.
44774
2.CONNECT UNION TO CONNECTOR TUBE HOSE
Connect the union to connector tube hose to the intake manifold.
12261
3.CONNECT VENTILATION HOSE
Connect the ventilation hose to the intake manifold.
4.INSTALL STUD BOLT
Using a "TORX" socket wrench E6, install the 3 stud bolts to the intake manifold.
22030
5.INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
6.INSTALL INTAKE SYSTEM