Home › Engine / Hybrid System › 2NZ-FE INTAKE / EXHAUST › INTAKE MANIFOLD
RM19S0E _51 Engine / Hybrid System _051457 2NZ-FE INTAKE / EXHAUST _0248115 INTAKE MANIFOLD A

2NZ-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 22030 1.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

Hide 2.REMOVE STUD BOLT

a.
A249588

Using a "TORX" socket wrench E6, remove the 3 stud bolts.


Hide 12261 3.DISCONNECT VENTILATION HOSE

a.
A249586

Loosen the clip and disconnect the ventilation hose.


Hide 44774 4.DISCONNECT UNION TO CONNECTOR TUBE HOSE

a.
A249587

Loosen the clip and disconnect the union to connector tube hose.


Hide 17111 5.REMOVE INTAKE MANIFOLD

a.
A259833

Disengage the 2 wire harness clamps and separate the wire harness.


b.
A259832

Remove the 2 bolts and the 2 wire harness brackets.


c.
A249593

Disengage the wire harness clamp and separate the wire harness.


d.
A249594

Remove the oil level dipstick.


e.
A105631

Remove the 2 nuts, 3 bolts and the intake manifold.


f.
A249596

Remove the gasket from the intake manifold.