Home › Engine / Hybrid System › 2NZ-FE COOLING › RELAY
RM19S0E _51 Engine / Hybrid System _051459 2NZ-FE COOLING _0248136 RELAY G

2NZ-FE COOLING  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85927 1.INSPECT FAN NO. 1 RELAY

E209082

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied 10 kΩ or higher
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.




Hide 85927A 2.INSPECT FAN NO. 2 RELAY

A159206E22
2.021,0.719 1.771,0.521 true 1.771,0.521 1.646,0.521 false 2.313,0.656 2.385,0.125 true 2.385,0.125 2.427,0.125 false 2.625,0.688 2.917,0.49 true 2.917,0.49 3,0.49 false 2.49,1.135 3.073,1.135 true 2.469,1.635 3.094,1.635 true 0.219,0.927 0.375,1.104 0.156,0.177 10 false 5 0.219,1.323 0.375,1.5 0.156,0.177 10 false 1 0.698,0.396 0.854,0.573 0.156,0.177 10 false 4 1.156,0.906 1.313,1.083 0.156,0.177 10 false 3 1.167,1.323 1.323,1.5 0.156,0.177 10 false 2 1.5,0.438 1.656,0.615 0.156,0.177 10 false 1 2.469,0.042 2.625,0.219 0.156,0.177 10 false 4 3.021,0.406 3.177,0.583 0.156,0.177 10 false 2 3.115,1.552 3.271,1.729 0.156,0.177 10 false 3 3.104,1.042 3.26,1.219 0.156,0.177 10 false 5

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery voltage not applied Below 1 Ω
3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage not applied 10 kΩ or higher
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.