Home › Engine / Hybrid System › 1NZ-FE LUBRICATION › OIL PUMP
RM19S0E _51 Engine / Hybrid System _051460 1NZ-FE LUBRICATION _0248140 OIL PUMP G

1NZ-FE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

B009329E01
2.97,0 3.414,0.125 0.444,0.125

a.

Coat the oil pump relief valve with engine oil and check that it falls smoothly into the valve hole by its own weight.

If not, replace the oil pump relief valve. If necessary, replace the oil pump assembly.


Hide 2.INSPECT OIL PUMP ROTOR SET

A117456E05
2.646,1.615 2.844,2.594 true 0.917,0.833 1.813,0.365 true 1.833,0.24 2.01,0.406 0.177,0.167 10 false *a 2.792,2.594 2.969,2.76 0.177,0.167 10 false *a

a.

Install the 2 rotors with both of the marks facing the oil pump cover side.

Text in Illustration
*a Mark


b.
B009331

Check the rotor tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

Standard driven rotor tip clearance:

0.060 to 0.180 mm (0.0024 to 0.0071 in.)


Maximum driven rotor tip clearance:

0.28 mm (0.0110 in.)


If the tip clearance is greater than the maximum, replace the oil pump assembly.



c.
B009332

Check the rotor body clearance.

i.

Using a feeler gauge, measure the clearance between the driven rotor and the oil pump body.

Standard body oil pump clearance:

0.250 to 0.325 mm (0.0098 to 0.0128 in.)


Maximum body oil pump clearance:

0.425 mm (0.0167 in.)


If the body clearance is greater than the maximum, replace the oil pump assembly.