Home › Engine / Hybrid System › 2NZ-FE LUBRICATION › LUBRICATION SYSTEM
RM19S0E _51 Engine / Hybrid System _051461 2NZ-FE LUBRICATION _0248141 LUBRICATION SYSTEM G

2NZ-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up and stop the engine, and then wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill with engine oil above the full level mark.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, entry of water, discoloring or thinning.

If the quality is visibly poor, replace the oil.


Hide 3.INSPECT OIL PRESSURE

a.

b.
A104878

Install the oil pressure gauge.


c.

Warm up engine.


d.

Check the oil pressure. If the oil pressure is not as specified, check the oil pump.

Oil Pressure:
At Idle At 3000 rpm
29 kPa (0.3 kgf/cm2, 4.4 psi) or more 150 to 550 kPa (1.5 to 5.6 kgf/cm2, 22 to 80 psi)



e.

Remove the oil pressure gauge.



g.

Check for the engine oil leaks.