Home › Engine / Hybrid System › 2NZ-FE LUBRICATION › OIL PRESSURE SWITCH
RM19S0E _51 Engine / Hybrid System _051461 2NZ-FE LUBRICATION _0248143 OIL PRESSURE SWITCH G

2NZ-FE LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Disconnect the oil pressure switch connector.


b.

Start the engine.


c.
A159695

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Idling 10 kΩ or higher
1 - Switch body Engine stopped Below 1 Ω



d.

Reconnect the oil pressure switch connector.

If the result is not as specified, replace the oil pressure switch assembly.