Home › Engine / Hybrid System › 2NZ-FE LUBRICATION › OIL PUMP
RM19S0E _51 Engine / Hybrid System _051461 2NZ-FE LUBRICATION _0248144 OIL PUMP A

2NZ-FE LUBRICATION  OIL PUMP  REPLACEMENT  


PROCEDURE

Hide 15100C 1.REMOVE OIL PUMP SEAL

A166952E04
0.427,1.177 0.271,0.542 0.271,0.542 1.292,0.396 false 1.458,0.833 1.99,0.281 true 2.01,0.156 2.177,0.323 0.167,0.167 10 false *1 0.125,0.375 0.292,0.542 0.167,0.167 10 false *2

a.

Using a screwdriver with its tip wrapped in protective tape, remove the oil pump seal.

Text in Illustration
*1 Protective Tape
*2 Splinter of Wood


Hide 15100C 2.INSTALL OIL PUMP SEAL

A166953E11
1.156,2.844 1.344,2.844 false 0.406,3.865 0.24,3.615 0.24,3.615 0.865,3.438 false 0.969,1.135 2.635,1.333 1.667,0.198 10 false 0 to - 1 mm (0 to - 0.04 in.) 1.375,2.76 1.677,2.917 0.302,0.156 10 false SST 0.083,3.469 0.24,3.625 0.156,0.156 10 false *1

a.

Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing chain cover.

Text in Illustration
*1 Splinter of Wood

SST
09950-60010  (09951-00250, 09951-00410, 09952-06010)
09950-70010  (09951-07100)

NOTICE:

Do not tap the oil seal at an angle.



b.

Apply a light coat of MP grease to the oil pump seal lip.

NOTICE:

Keep the lip free of foreign matter.