Home › Engine / Hybrid System › 1NZ-FE STARTING › STARTER
RM19S0E _51 Engine / Hybrid System _051462 1NZ-FE STARTING _0248146 STARTER A

1NZ-FE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the connector.


c.

Connect terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Close the terminal cap.


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.

Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

NOTICE:
·

Make sure that the claw makes a click sound, indicating that it fits tightly.

·

Replace the flywheel housing side cover with a new one if it does not fit tightly or is deformed.




Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)