1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
11363A
3.REMOVE FLYWHEEL HOUSING SIDE COVER
Disengage the claw by pulling it outward and remove the flywheel housing side cover.
28100
4.REMOVE STARTER ASSEMBLY
Open the terminal cap.
Remove the nut and disconnect the terminal 30.
Disconnect the connector.
Remove the 2 bolts and the starter assembly.
| *1 | Terminal 30 |