Home › Engine / Hybrid System › 1NZ-FE STARTING › STARTER
RM19S0E _51 Engine / Hybrid System _051462 1NZ-FE STARTING _0248146 STARTER A

1NZ-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A250021

Using a 7 mm socket wrench, remove the 2 bolts.


b.
A249983E01
1.72,0.591 1.906,0.752 0.186,0.161 10 *1 1.412,0.685 1.685,0.685 false 1.28,1.352 1.466,1.513 0.186,0.161 10 *2 1.484,1.453 1.685,1.453 1.685,1.453 1.685,1.154 false

Remove the hook from the starter pinion drive lever while lifting the rear of the magnet starter switch assembly, and then remove the magnet starter switch assembly.

Text in Illustration
*1 Starter Pinion Drive Lever
*2 Hook


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A249977

Using a 7 mm socket wrench, remove the 3 through bolts.


b.

Remove the starter yoke assembly.


Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A248647

Remove the starter commutator end frame assembly.


b.
A248649E01
1.594,0.812 1.211,0.812 false 1.005,0.728 1.173,0.881 0.168,0.153 10 *1

Remove the starter yoke assembly while holding down the starter armature assembly and the starter brush holder assembly with the handle of a hammer.

HINT:

The starter armature assembly will be attracted by the magnetic field of the starter yoke assembly, so the starter armature assembly is held with the handle of the hammer.


Text in Illustration
*1 Hammer


Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A248650

Remove the starter armature assembly from the starter brush holder assembly.


Hide 28021 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A249978

Remove the rubber seal from the starter drive housing assembly.


b.
A249979

Remove the starter center bearing clutch sub-assembly from the starter drive housing assembly.


c.
A250735

Disengage the 3 claws and remove the starter armature plate from the starter center bearing clutch sub-assembly.


d.
A248654

Remove the 3 planet gears from the starter center bearing clutch sub-assembly.