Home › Engine / Hybrid System › 1NZ-FE STARTING › RELAY
RM19S0E _51 Engine / Hybrid System _051462 1NZ-FE STARTING _0248148 RELAY G

1NZ-FE STARTING  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 28300 1.INSPECT STARTER RELAY

E209082

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied 10 kΩ or higher
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.