Home › Engine / Hybrid System › 2NZ-FE STARTING › STARTER
RM19S0E _51 Engine / Hybrid System _051463 2NZ-FE STARTING _0248150 STARTER A

2NZ-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 11363A 3.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A248646

Disengage the claw by pulling it outward and remove the flywheel housing side cover.


Hide 28100 4.REMOVE STARTER ASSEMBLY

A247237E01
1.376,0.546 0.749,0.245 0.749,0.245 0.521,0.245 false 0.316,0.163 0.490,0.344 0.175,0.181 10 *1

a.

Open the terminal cap.


b.

Remove the nut and disconnect the terminal 30.


c.

Disconnect the connector.


d.

Remove the 2 bolts and the starter assembly.

Text in Illustration
*1 Terminal 30