Home › Engine / Hybrid System › 2NZ-FE STARTING › IGNITION SWITCH
RM19S0E _51 Engine / Hybrid System _051463 2NZ-FE STARTING _0248151 IGNITION SWITCH G

2NZ-FE STARTING  IGNITION SWITCH  INSPECTION  


PROCEDURE

Hide 84450 1.INSPECT IGNITION OR STARTER SWITCH ASSEMBLY

a.
A247262E07
1.229,3.625 0.813,3.292 false 1.948,3.625 2.396,3.188 false 2.24,3.688 2.656,3.688 false 2.25,3.979 2.479,4.292 false 1.49,4 1.271,4.313 false 1.875,4.031 1.875,4.333 false 1.031,0.177 1.396,0.406 0.365,0.229 10 false *b 2.031,0.292 2.396,0.521 0.365,0.229 10 false *c 2.375,0.771 2.74,1 0.365,0.229 10 false *d 2.385,1.354 2.75,1.583 0.365,0.229 10 false *e 0.479,3.167 0.99,3.438 0.51,0.271 10 false AM1 2.406,4.313 2.896,4.531 0.49,0.219 10 false AM2 1.833,4.365 2.323,4.583 0.49,0.219 10 false IG2 1.083,4.375 1.573,4.594 0.49,0.219 10 false ST2 2.427,3.01 2.938,3.281 0.51,0.271 10 false ACC 2.719,3.594 3.229,3.865 0.51,0.271 10 false IG1 0.115,2.76 0.344,2.927 0.229,0.167 10 false *a

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
Between all terminals LOCK 10 kΩ or higher
2 (ACC) - 4 (AM1) ACC Below 1 Ω
1 (IG1) - 2 (ACC) - 4 (AM1) ON Below 1 Ω
5 (AM2) - 6 (IG2)
1 (IG1) - 4 (AM1) START Below 1 Ω
5 (AM2) - 6 (IG2) - 7 (ST2)


If the result is not as specified, replace the ignition or starter switch assembly.

Text in Illustration
*a Component without harness connected
(Ignition or Starter Switch Assembly)
*b LOCK
*c ACC
*d ON
*e START