Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248153 CRUISE CONTROL SYSTEM U

CRUISE CONTROL  CRUISE CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Cruise Control / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Cruise Control
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
CCS Vehicle Spd Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) Actual vehicle speed displayed -
CCS Mem Vehicle Spd Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) Vehicle speed stored in memory -
Throttle Opening Angle Required throttle opening amount / Min.: 0°, Max.: 124.5° Required throttle opening angle -
Cruise Control Cruise control / OFF or ON OFF: Cruise control not set
ON: Cruise control set
-
Main SW M-CPU Cruise control main switch (Main CPU) / OFF or ON OFF: Cruise control main switch off
ON: Cruise control main switch on
-
CCS Ready M-CPU Cruise control system standby condition (Main CPU) / OFF or ON OFF: Cruise control main switch off
ON: Cruise control main switch on
-
CCS Indicator M-CPU Cruise control indicator (Main CPU) / OFF or ON OFF: Cruise control indicator light off
ON: Cruise control indicator light on
-
Cancel Switch CANCEL switch signal / OFF or ON OFF: CANCEL switch off
ON: CANCEL switch on
-
SET/COAST Switch -SET switch signal / OFF or ON OFF: -SET switch off
ON: -SET switch on
-
RES/ACC Switch +RES switch signal / OFF or ON OFF: +RES switch off
ON: +RES switch on
-
Stp Light SW M-CPU Stop light switch signal (Main CPU) / OFF or ON OFF: Brake pedal released
ON: Brake pedal depressed
-
Cruise Operation Status Shift lever position signal / OFF or ON OFF: Shift lever not in D
ON: Shift lever in D
-
Brake Cancel Switch Brake cancel signal / OFF or ON OFF: Brake pedal released
ON: Brake pedal depressed
-



ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise control indicator light OFF/ON Vehicle is stopped and engine is idling
Indicat. SET Cruise control SET indicator light OFF/ON Vehicle is stopped and engine is idling