If the following conditions are detected while cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels cruise control.
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
|---|---|---|
| Cruise control indicator light blinks | ·
There is an open or short in the stop light switch circuit ·
There is a problem with the vehicle speed signal |
Turn the cruise control main switch on again |
| Cruise control indicator light goes off | There is a problem with the throttle body with motor assembly | |
| Cruise control indicator light blinks | ·
There is a problem with the input circuit of the stop light switch circuit ·
There is a problem with the cancel circuit |
·
Turn the cruise control main switch on again ·
Turn the ignition switch off and then to ON again |
| Cruise control indicator light remains on
(Cruise control is canceled) |
Under either of the following conditions, cruise control operation is canceled but the stored vehicle speed is maintained:
·
The vehicle speed is less than the low speed limit (approximately 40 km/h (25 mph)) while driving with the cruise control system in operation ·
The vehicle stability control system is operated*1 |
Push the cruise control main switch to +RES |
| Under the following condition, cruise control operation is canceled but the stored vehicle speed is maintained:
·
The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more |
Push the cruise control main switch to -SET |
*1: w/ VSC