Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248154 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84632 1.INSPECT CRUISE CONTROL MAIN SWITCH

E346475E01
3.906,1.156 3.667,0.615 false 5.104,1.156 5.49,0.625 false 2.979,3.396 2.75,3.094 true 1.885,3.375 2.125,3.094 true 0.406,0.271 0.719,0.469 0.313,0.198 10 false *a 3.51,0.5 3.823,0.698 0.313,0.198 10 false *c 5.531,0.479 5.844,0.677 0.313,0.198 10 false *b 5.906,1.281 6.219,1.479 0.313,0.198 10 false *d 5.052,2.354 5.365,2.552 0.313,0.198 10 false *e 4.594,0.531 4.906,0.729 0.313,0.198 10 false *f 3.906,2.156 4.219,2.354 0.313,0.198 10 false *g 1.521,3.313 1.979,3.51 0.458,0.198 10 false CCS 3.042,3.323 3.5,3.521 0.458,0.198 10 false ECC

a.

Measure the resistance and check the results in accordance with the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Cruise Control Main Switch)
*b Cruise Control Main Switch
*c Lever *d ON/OFF
*e -SET *f +RES
*g CANCEL - -

Standard resistance:
Tester Connection Switch Condition Specified Condition
1(ECC) - 3(CCS) Main Switch off*1 1 MΩ or higher
Main Switch on Below 2.5 Ω
+RES 235 to 245 Ω
-SET 617 to 643 Ω
CANCEL 1509 to 1571 Ω


*1: The lever is in the neutral position.

If the result is not as specified, replace the cruise control main switch.