84520E
1.INSPECT CLUTCH SWITCH ASSEMBLY
Check the resistance between the terminals when the switch is ON and OFF.
| *a | Component without harness connected
(No. 2 clutch start switch assembly) |
| *b | 7.65 to 8.35 mm (0.301 to 0.329 in.) |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | OFF (released) | 10 kΩ or higher |
| ON (pushed in) | Below 1 Ω |
If the result is not as specified, replace the No. 2 clutch start switch assembly.