Home › Drivetrain › U340E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
RM19S0E _52 Drivetrain _051465 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0248156 AUTOMATIC TRANSAXLE SYSTEM D

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1 trip detection logic.



CHECK MODE PROCEDURE


HINT:

intelligent tester only: Compared to normal mode, check mode is more sensitive for detecting malfunctions. Furthermore, the same diagnostic items which are detected in normal mode can also be detected in check mode.


a.

Procedure for check mode using the intelligent tester.

i.

Check the initial conditions.

·

Battery voltage 11 V or more

·

Throttle valve fully closed

·

Shift lever is in P or N.

·

A/C off.



ii.

Turn the ignition switch off.


iii.

Connect the intelligent tester to the DLC3.


iv.

Turn the ignition switch to ON.


v.

Turn the intelligent tester on.


vi.
A076900E58
0.344,0.677 0.573,0.875 0.229,0.198 10 false ON 0.292,1.552 0.583,1.75 0.292,0.198 10 false OFF 2.021,0.417 2.865,0.615 0.844,0.198 10 false 0.13 seconds 0.344,1.823 1.188,2.021 0.844,0.198 10 false 0.13 seconds

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode (Check that the MIL flashes as shown in the illustration).

NOTICE:

All DTCs and freeze frame data recorded are erased if: 1) the intelligent tester is used to change the ECM from normal mode to check mode or vice-versa; or 2) during check mode, the ignition switch is turned from ON to ACC or LOCK.



vii.

Start the engine (the MIL goes off after the engine starts).


viii.

Perform Monitor Drive Pattern for the ECT test (See page Drivetrain>U340E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>MONITOR DRIVE PATTERN), or simulate the conditions of the malfunction described by the customer.

NOTICE:

Leave the ignition switch ON until you have checked the DTCs.



ix.

After simulating malfunction conditions, use the intelligent tester to check the DTCs and freeze frame data.